Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to set up T.37 fax but can't find any documentation on how to get it working in a slightly different configuration. I have a 2811 with a VWIC-2-MFT terminating a PRI and Data T-1 with the PRI being terminated by MGCP. I would prefer to ha...
I think I have something a little wrong, I have things working for login via radius but when I authenticate it only gives me privilege level 1 when I have "shell:priv-lvl=15" in the IAS config followed by Login per several doc's I have found. Here is...
Yes it's possible to use .Net, but it wasn't easy. In order for me to do it I created a page that only contained a literal and then you'll have to output everything manually as you want it to appear to the phone to use .Net server side. Then request....
Well, I had hoped I could terminate from a VoIP dial-peer, but what I did end up with was this:Bring PSTN PRI in via vwic-2MFT configured with MGCP.Hiarpin call from Call Manager to h323 gateway configured on the same router prefixed with a 9.Send ca...
Actually your correct in your assumption I am not trying to do this on the console, yet. Once I have full monitoring up so I can see downtime on each one and check for changes (or preffereably just set up network loads) then it will be a predominatel...
How are you powering them? Via inline power or Cubes?I have seen that the cubes often times seem to not connect to the power cord from the wall very well and leaves the phone "dead" and reseating the power cord often times will fix the problem. On th...
Did you enable your VLan's in VTP? Are you running VTP? If you left your administrative VLan on VLan 1 then just created VLan 100 that could be part of the problem.
