Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyonecrazy issue here.. everything looks like it should be working but doesnt! a summary would be our 3750 switches will not trunk over fiber (SM or MM) to our core 6500. They work just fine over copper.The funny thing is, ONE 3750 works ove...
so, after troubleshooting for 7 hours with a Cisco switching expert, we finally determined the cause. Turns out, 1 of 2 supervisor modules (WS-SUP720-3B) had fabric errors, resulting in fiber ports unable to build trunks/access.replaced the supervis...
Leo, the issue is new 3750s will not pass layer 3 across any fiber trunk to the 6500. i have a test switch physically sitting in front of the 6500, with an LC-LC single-mode patch cable. it will not ping thru 5/1, 6/1, or any other port except 3/43 (...
Leo: you are seeing 0 tx/rx load because it was unplugged. here is the result when its plugged in:GigabitEthernet6/1 is up, line protocol is up (connected) Hardware is C6k 1000Mb 802.3, address is 001a.a22d.6984 (bia 001a.a22d.6984) Description: Fi...
there are several fiber ports in use on mod 3 and mod 4 working fine. rack switches, remote switches, etc.any new trunks we try to add only get L2.Mod Ports Card Type Model Serial No....
