Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone
I have a CISCO2921/K9 router running 15.1(4)M4, I entered follow commands :
##########################################################
ip subnet-zero
no service finger
no boot network
##################################################...
Hi allIt‘s a 3750 switchMy colleague can login to the device remotely via SSH，But when he Telnet to the other equipment in 3750 by cli，3750 will be instant high CPU, The device will not work properly。model and ios versionWS-C3750G-24TS 12.2(55)S...
My WLC mode is 5508, code is 7.4.110.0(7.0.230.0 upgrade to 7.4.110.0)One SSID needs web auth,but when the clients connected to this SSID,it can redirect to web auth page, after user login ,login page pop up again. this problem is not happened before...
HelloI have two WLCs,The primary WLC mode 5508 ,running code is 7.4.100.60, The secondary WLC mode 4402,running code is 7.0.230.0.When ap working on 5508 wlc,it use flexconnect mode, when ap working on 4402, it will h-reap modeap mode:1242、1142.quest...
Hi Reza
"Usually if a command is disabled or enabled by default, the IOS does not show it in the running config. For example, in the newer IOS versions ip subnet-zero is enabled by default, so the IOS does not show it in the config."
Is there a duc...
dear GeorgeWLC 4402 can only upgrade to 7.0.xxx.xxto manage 2600 series ap,WLC 5508 must upgrade to a newer version.I'm sorry i didn't make a detail description, there are some 2600 series of AP on 5508, these APs needn't to fail over.
