Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Some texts show that type 4 lsa is allowed inside a stub area ? is it tru ..?The ABR sends a type 3 default route into the area by default (Whether it has a default route itself or not)Regarding the totally stub area , no type 3,4,5 are allowed and o...
Hi all,As far as I understand..DR/BDR Election takes place using hello protocol and is based on the interface priority ..and in case of a tie ..the higher Router-id wins and becomes DR. In case DR goes down..the BDR takes over as DR and another route...
Dear all,I have a specific requirement which I want to fulfill using policy based routing. However , it is not working as expected. The scenario is as follows:I have a few vlans on MSFC, eg Interface vlan 1-5 with IP addresses 1.1.1.1 to 5.5.5.5 resp...
Hello all,need help in configuring transparent caching using CSM on cat6500. I shall be thankful if anyone could provide some useful info/configuration guidelines with a little explaination of the steps involved. TIASudhir
I am trying to configure Transparent caching on Cat 6500 with CSM in routed mode, but facing some problems in it , also I have gone thru the example config on cisco site for transparent caching using CSM on Cat 6500 , but the above does not fit my cl...
Thanks Marikakis, The point I want to make is :-As you said, when R3 ( The Router who was DR ) goes down , R2 ( The BDR ) is promoted to DR and R1 (DROTHER) becomes BDR. Also, it is stated at many places that DR-BDR Election is NOT Pre-emptive. So, W...
Transparent Cache for clients only. The design is quite simple actually.I have a cat6500 with 5-6 vlans on MSFC which is connected to the external router for internet. Requirement is to make the clients on these vlans browse/download content from the...
Thanks Natalia,I know it already and have configured the Cat6500 accordingly. But even when I try to assign same address to both the client and server vlan as depicted in the sample configuration , I get the address overlaps error.Anyways , thats not...
Dear Mr Joerg,I tried using the configuration example, shown by the URL sent by you, but I am not able to configure both vlans with the same address as shown in the example, I keep getting the message about address overlaps ... Can I request you to s...
