Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
We use cisco 3850 switchs for our wireless with a converged setup.
I'm trying to setup 3 google home devices on a new wlan which is setup as employee and it's not working. It complains of ap isolation problems and also uPNP not working...
Hi All, Can somebody suggest a straight forward method to limit bandwidth used of one of our wlans, the guest one. I've tryed to apply a policy/class map to the guest Wlan, to the vlan itself etc with no joy. I've looked at limiting limit bandwidth...
Go to a different firmware version. I've got it working again at 3.6.3. I updated to 7.2 which broke it again but 3.6.3 see,s to the latest that works. Hope that helps.
Just for Ref if it helps anyone or plan to investigate the problem. All of my switchs have ip http server and ip http secure-server in the config. They were all part managed via cna before being upgraded to 3.6.2/3.7.2 beforehand fine.
Thanks Mark & Marvin,
I seem to have a knack of picking the buggy versions. After a bit more testing it seems 3.6.2 which is what I upgraded a mass of switchs to a while back do not like connecting to network assistant. I didn't have time to inves...
Hi Mark,
Should WS-C3850-48 p switchs be supported in network assistant? I have some that run 3.6 that I can connect to and some on 3.62 that aren't. I've tryed 3.7.02 on one and that dosen't work either?
Any ideas?
Thanks,
