Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I read an article that mentioned circularized polar antenna's. Can someone tell me where(what type of application)they would be used and also give a Cisco part number? Thanks...
I am installing a point to point bridge link using 1400 briges w/power injectors. The bridges are installed but the link goes up and down about every few minutes. When it does connect, it starts out at a low dbm but eventually ends up in the 80's a...
Is there any problems or harm that can occur using the 802.11a,b or g technologies around people wearing/using pacemakers or other medical devices like that? Also, is there a website that may contain some of this information?
Has anyone ever used a 350 Bridge and connected to a 350 WorkGroup bridge? We have an application where the two buildings are only about 1/8 mile apart and the farend(workgroup bridge end) would have 3-4 computers attached. It is possible to attach...
We have an application where we will be connecting two buildings using wireless. The far-end will have approximately 3-4 computers attached the network. Should I use a 350 bridge at the near-end and a 350 workgroup bridge at the far-end with a hub ...
Very good answer. Your right, we do not have Cisco Aironet extensions enabled but we do only have Cisco clients. We will enable that and see what happens. Thanks
Here is the exact error message in the log:2002 Mar 07 06:28:40 CST -06:00 %SYS-4-P2_WARN: 1/Host 00:40:96:37:70:fa is flapping between port 2/1 2/2 and port 2/6Thanks