Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On C4900 i am not able to change the config-register value to 0x2102. In the config mode i gave the command "config-register to 0x2102" and did a write memory. After which when i do a "show ver", it does not reflect that the config-register value wil...
Hi All, Recently there was change done on Wan link where the MTU was set to 9000. The same value has been set on the ISP end too. The Network connectivity is as given: CE1 ---- PE1 ---- PE2 ---- CE2On the CE Interfaces connecting to PE's, the MTU has...
How to login into Switch Processor (SP) on 6500?Below is the show version output of the device in question:Cisco Internetwork Operating System SoftwareIOS (tm) MSFC3 Software (C6MSFC3-PSV-M), Version 12.2(17a)SX1, EARLY DEPLOYMENT RELEASE SOFTWARE (f...
Below is the show version output:Cisco Internetwork Operating System SoftwareIOS (tm) MSFC3 Software (C6MSFC3-PSV-M), Version 12.2(17a)SX1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)TAC Support: http://www.cisco.com/tacCopyright (c) 1986-2003 by cisco S...
@ Leo Solano What i dint recongnize in the begining was, the L2 & L3 fuctions of the swtich had Different Hostnames assigned to them. I was using the L3 Hostname instead of first using the L2 Hostname for logging in.Now that i logged into L2, from...
@jon.marshall Thanks for the info Jon. What i dint recongnize in the begining was, the L2 & L3 fuctions of the swtich had Different Hostnames assigned to them. I was using the L3 Hostname instead of first using the L2 Hostname for logging in.Now that...
