Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Two 4500x devices are in VSS. secondary device is in standby mode..after taking console it shows standby after hostname into brackets. this standby mode doesn't allow to configure device like primary....
unlike in cisco stack device if we connect ...
Hi,
I am confused between Routing abilities of M series and F series card card of Cisco Nexus.
F1 don't support Routing, F2e & F3 support routing
M series since initially support routing.
Now if F series (F2e & F3) and M series both card support ...
Dear all...
As captioned in title line.. we have one router in our network, having one rp 10.1.250.250 which is mapped with 4 multicast group...what working fine.
As per our new requirement, we want to use same router for one another rp address e.g....
Thanks Clsulliv,
This is right ans but seems very short because many Qns arises
Can you tell or share some links what can help me to understand me first what is the logic or idea behind F and M series line cards.
if M3 modules have moved to a S...
Hi chrihussey
Thanks once again...
it means ip pim rp-address y.y.y.y will not override on old ip pim rp-address x.x.x.x ??
both can be work same time only mapped acl should not be overlap... right
Can you share any doc what can explore all this thi...
Hi,
Only one switch is there; 1 multicast feed sender server & 4 receiver machine clients are connected to same switch on different different port..(no hub nothing)... by default all ports are in vlan1; nothing extra is configured; all is default;
so...
Hi, Thanks for your response...
ok.. layer 2 link status which can generate syslog message & layer 2 netflow.....agreed.
if both layer 2 links are not trunk then ??
if both layer 2 links are in etherchannel ?? & if one link of etherchnnel is down or ...
