Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi team,
Change of Authority - Port bounce, not working on host-mode multi-domain fast ethernet interface.
Unfortunate to say that the company I'm working for still has a few Cisco Catalyst 2960 series switches running on 15.0 firmware version. I am ...
We are going to aggregate two GIG ports of NCS router and connect to the Non -Cisco Layer 03 core switch stack. Please refer to the below mention diagram for more understanding
As per above diagram
Configuration already made on Cisco NCS 54...
Hi Everyone,
I already have fresh Cisco N540(N540-12Z20G-SYS-A) routers. I need to configure below mentioned configuration on that router:
How to enable https web access via MGMTEthernet interface?If there is any possibility to create Link Aggregatio...
We are not use Authentication servers to authenticate wireless users.Just use only WPA 2 encryption mode for authenticate wireless users.But we identified there are lot of EAPol timeouts happened during the client authentication
What would be the is...
We purchase newly a CISCO 5585-x firepower ssp 10 and firepower module is running 5.4.0.764 version and we need to upgrade it to 6.1
But when i try to upgrade through firesight management, It shows no appiance found
I tried with all the upgrade from...
Yes Did it, but not working still port is not up
shutdown
Switch(config)#interface range gigabitEthernet 2/0/49-50Switch(config-if-range)#shuSwitch(config-if-range)#shutdownSwitch(config-if-range)#*Mar 1 01:01:48.561: %LINK-5-CHANGED: Interface Gigab...
RP/0/RP0/CPU0:HQR01#show lacp bundle-Ether 1Fri Jun 30 15:59:49.236 UTCState: a - Port is marked as Aggregatable.s - Port is Synchronized with peer.c - Port is marked as Collecting.d - Port is marked as Distributing.A - Device is in Active mode.F - D...
okay.. but how can I use port-channel instead of bundle in the NCS? coz as per the my reference i unable to find how to config port-channels on NCS instead of Bundles
