About ttherkildsen

ttherkildsen · 02-27-2006

Hi there!I have an 6500 IOS switch where i am using a policy for Voip trafic and i works for serial interface but not for my Gigabit interface !class-map match-all VOICE-CONTROL match ip dscp cs3class-map match-all VOICE match ip dscp ef!!policy-ma...

ttherkildsen · 02-20-2007

Hi Dave I am trying to find some information on how to setup the WLSM i Hotfailover, maybe you can sent some information to me.(i am not sure if i want to set it op as intra chassi og interchassi yet)Thomas Therkildsen

ttherkildsen · 02-28-2006

Hi Again ,,Sorry my mistake it is in the config , i was cut- past from an old config, the interface is a routed interface, it is used the same way as serial interface 3/1/0 byt our line supply Ethernet L2 Wan link.i am saying that there is no hit in ...

ttherkildsen · 02-27-2006

Hi Just want to say thank you, now i will try to see if i can understand the the doc , you posted to Thanks

ttherkildsen · 02-27-2006

Hi Again Yes i trust DSCP on incoming int, ( it works on serial int,)here is the out put for sh policy map and int. config . i have also put in the serial so you can see that it works on serial sh run int gigabitEthernet 7/45Building configuration.....

ttherkildsen · 06-28-2005

Hi It seems like i have the same problem getting Tacacs login to work, i i try to type in"aaa authentication login default group tacacs+ enable none" Then i will loos access to the WLSM, however i have not saved my config so i can just restart the mo...

Member Since	‎11-06-2003 09:41 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	7

User Statistics

User Activity

Service-policy on gigabit interface not working

Re: Redundant WLSM

Re: Service-policy on gigabit interface not working

Re: Service-policy on gigabit interface not working

Re: Service-policy on gigabit interface not working

Re: reset to default configuration on WLSM