Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!
I can't find direct information about L3 interoperbility between 2 pair of N5k via vPC.
My question is:
Is it correct to establish EIGRP neighbor relationship between two pair of Nexus N5k that are linked via vPC in a trunk mode?
Now i have th...
Hi all!I have one question about selecting static routes:If router have two routes to some destination like:ip route 192.168.1.1 255.255.255.255 172.16.1.1 (tunnel 1)ip route 192.168.1.1 255.255.255.255 172.16.2.1 (tunnel 2) Status of tunnels is UP. ...
All tunnels are up. And both routes in routing table. But if i do tracert router always uses the oldest route.
When i do "sh ip route" the oldest route is always with * and router uses it.
I have no load balancing only the oldest route.
I have to notice, that "show ip route" always shows the first route, that has been added to router, as used.And there is no load balancing.May be router uses the oldest route?
Hello. Thanks for answer.sh env is OK for cat 6500 as example, but in cat. 2960 there is no such output.WS-C2960-48TT-L for examle:============================sh env allFAN is OKTEMPERATURE is OK POWER is OKRPS is NOT PRESENT========================...
