Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I checked under our service policy in March and the icmp packets were at 13,743Inspect: icmp, packet 13743, drop 0, reset-drop 0I checked it again today and its now at 1,608,004Inspect: icmp, packet 1608004, drop 24, reset-drop 0 Anybody know what co...
We added VOIP to one our of offices and now some people cannot get out to the internet. The ASA has 10 host it can use. I'm guessing we need to add more host to it. How do we add more licenses?
So I need to forward TCP 80 to a 10. IP.on one of our switches. I see this switch has one ACL in it. ACL 199. Do I set up the port on that ACL or do I need to set up a outside ACL just for that port and IP?And do I have to set it up in any other swit...
So we have FA0/13 configured to use our Aerohive wirless. But for the past week its been losing the turnk config and I have no idea why. Heres the config we have in the 3550 switch for that interface. This interface is trunked to all of our VLANsi...
I dont know if this will help but it mighthttps://www.dropbox.com/s/31smb84hdc8dix5/oMG-TN-121107%20Cisco%20ASA5505%20IPsec%20Configuration%20Guide_Certificates%20for%20Rel3%20SW%20%20R1.1.pdf
I have the access point set up. I just need to set the ASA up. Under the group policy the command when using IP address is vpn-framed-ip-address. But Im using the MAC address since the IPs they have are dynamic. I dont know what command to put in pla...
Actually my question has changed. This is the first user who will be using a VPN client. So I need to set upthe vpn client with the new user in the command line. Anybody know what all commands I need?
