Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone.
I'm trying to configure and route over a lag between two SG300 switches, rather than "stack" them together.
I have watched a lot of youtube videos and read articles on how to do this, but their subjects are based in the Catalyst world...
HI all.
I have two sg200 series switches and a Cisco ASA 5505.
I bought the switches a few years ago and stuck them together on layer 2 for simplicity's sake, but now, for fun, I'm converting my flat network to a L3 network. I still have my layer 2 s...
Hi all,Just for fun, I'd like to move to Fiber, running the trunk ports between my two Cisco SG300 lab swiches but I'm new to the media. Looking at the options, I thought that MM (MGBSX1) is the way to go, but the "Official" SFP's cost an arm and a l...
Sitesh, you've gotten to the root of my problem, of having two layer three devices connected only in a layer 2 manner. To obtain the functionality I want, I will have to put one in layer 2 mode, or configure routing between the two switches. This i...
Thanks for your assistance Ritesh. I did find a solution to my problem once I actually read the admin guide. For what I need, I used a loopback interface on the second switch as some of the SVI's I created are not yet assigned to ports.
