Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2700 & 2800 series AP's, that have 2.4 and 5Ghz SSID being broadcast from them.If I disable/enable the 2.4Ghz WLAN on the WLC the 2.4Ghz radio (dotRadio0) is reset which is understandable.But each time the 2.4Ghz WLAN is enabled the 5Ghz (DotR...
Hi,
Can someone please advise on the most appropriate QoS configuration to be used on a Catalyst switch port (3560, 3650,3750 etc)
My scenario is:
Wireless mobile client devices used for Data and Voice applications connect to one of multiple SSID's...
Hello,We currently discover our devices using a Ping-Sweep IP range that has the WAN IP addresses of all our site routers, and also enable CDP discovery so that all our site switches that reside behind each router can also be discovered. - This solut...
Turns out this is expected when doing local switching and flexconnect, how annoying ! When in production, if a WLAN is added to or deleted from an AP/FlexConnect group, the already authenticated clients from all other WLANs will be momentarily deauth...
Hello Rafael Thank you for your reply, however if enabling or disabling a WLAN is classed as an SSID change (which I do not think it should be), why does my 5Ghz radio reset when the 2.4Ghz only WLAN is enabled but doesn't when it is disabled?The 2....
Also these are the messages from the AP Log when:The 2.4G WLAN is disabled (shows just the 2.4 radio reset)TEST#*Sep 2 12:53:21.075: %DOT11-5-EXPECTED_RADIO_RESET: Restarting Radio interface Dot11Radio0 due to interface reset*Sep 2 12:53:21.083: %LIN...
Hi Rasika Thank you for your suggestion.Attached is the output I get when the 2.4Ghz WLAN in Enabled (The 5Ghz radio resets only when the 2.4 WLAN is enabled, not when it is disabled)
I had a similar issue with deleting and re-adding devices, which was resolved by installing device pack 5https://software.cisco.com/portal/pub/download/portal/select.html?&mdfid=286236028&softwareid=286208063 Might be worth a try.. Rowan
