Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Spa504G phone is on Firmware 7.5.7. PBX is asterisk 11.
The first 11 line keys are set to BLF, Speed Dial, Call Pickup, they work just fine.
The next set of line keys are set to Speed Dial only:
eg:
fnc=sd;sub=1XXXXXXXXXX@192.168.3.254
These line k...
I followed the cisco router dual WAN failover guide at http://docwiki.cisco.com/wiki/NAT_failover_with_DUAL_ISP_on_a_router_Configuration_Example
If I remove the ethernet cable or shutdown interface Gi0/1 or the modem that is its gateway reboots or p...
Sorry if this is too simple question of a question. Perhaps it's terminology, but I'm unsure whether I have found the correct information.
I have a block of IP addresses from my ISP. My router is currently using one of them.
Just as an example, let...
I have a number of port mappings/forwards, and I cannot figure out why I am able to access them outside of my ACLs. As per the documentation "There is an implied deny for traffic that is not permitted. A single-entry ACL with only one deny entry has ...
Provisioning a new set of spa504G phones. I've always used for spa504G.cfg, the phone finds it. I've always used:<flat-profile><Resync_On_Reset>Yes</Resync_On_Reset><Resync_Periodic>3600</Resync_Periodic><Profile_Rule>tftp://ipaddress/xml/spa$MA.xml<...
Thanks guys,
Sorry that I never updated this. For the 1921 I needed the datak9 license. As the first answer points out, I needed IP SLA. This allowed me to setup tracks for the main route (as second answer points out); the first track I setup pings o...
Thanks.
Sorry for the incorrectly worded statement. I do not want it to use the same public IP, but rather a different public IP within the same public subnet.
In terms of failover it depends on whether the IP you are using is from one of the ISPs...
two lan subnets (one interface)interface GigabitEthernet0/0 description LAN Interfaceinterface GigabitEthernet0/0.200two wan interfaces:interface GigabitEthernet0/1 description Comcast WAN linkinterface GigabitEthernet0/0/0 description Integra WAN li...
