Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco TAC does not support EEM. Below is the verbiage from the ticket. Can someone please assit? My EEM script has parts that at are recycled from existing working scripts and part that I lifted from Cisco's website. Ultimately I want to send an emai...
Hi All!!!I am running a PIX 515 failover pair running 6.3.5 and get the error message that follows:"No translation group found for tcp src lyontwp-secure:172.16.7.69/52955 dst inside:4.2.2.2/9100"I am trying to use NAT Exemption to bypass NAT entirel...
I am trying to configure SPAN for protocol analysys.The following is my configuration...monitor session 1 source interface fastEthernet 0/1monitor session 1 destination interface f0/29To me this means all traffic sent or received on port f0/1 will be...
I have dual pix's configured for stateful failover. If and when a fialover change occurs the active PIX has no IPSEC and ISAKMP security associations active and the remote end (an 831) thinks it still has an active tunnel. At the remote end I have to...
I read the document with the following URL of...http://cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094aad.shtmlAnd the following reads..."IP addresses in the pool of global addresses specified with the global command requir...
(Herbert, In my last post I did not say I appreciate your assistance and patience in assisting with this issue, I truly do...) Thank you Herbert but I cannot enter identity NAT or NAT exemption entries for every host that exists on the internet. 4.2....
Thank you Herbert but I cannot enter identity NAT or NAT exemption entries for every host that exists on the internet. 4.2.2.2 was only an example of a host (not even a host we own) siting out on the internet.Can I not do:access-list nonat permit ip ...
Vikram,Thanks for the reply!Unfortunately I already tried that and still a no go.Hebaerte,Likewise, thank you for the reply!4.2.2.2 is on the inside so yes traffic is flowing from a lower security interface (internal network) to a higher (internal ne...
Seth,I saw you have been asking this question for quite some time (with no replys) and what you want to do is something I have been wanting to do so I open a ticket with TAC and below is the response from the TAC tech. It at least will get us both st...
