Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question about the basic functioning of the ipsec tunnel in a site-to-site ipsec vpn connection. I need to be able to ping the external/outside interface of a Cisco 1711 router at a branch office. When I set up the 1711 just as a wide-open...
Just getting started on setting up my branch offices with 1711's. Moving 27 branch offices off of Frame Relay onto DSL connections. Goal is to setup vpn tunnel to corporate HQ by putting 1711 at each remote site. Will enable split tunnel, so web b...
I'm trying something similar. Using a PIX515E as the headend device and a 1711 router as the branch end device. The branch office uses a 192.168.10.x ip netblock, and the 1711 nats the internal and external interfaces. The PIX is doing NAT/PAT, al...
Here's the config from the PIX at the other end (at HQ):PIX Version 6.3(3)interface ethernet0 autointerface ethernet1 autointerface ethernet2 auto shutdownnameif ethernet0 outside security0nameif ethernet1 inside security100nameif ethernet2 intf2 sec...
