Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiIm running into a few issues when trying to update anyconnect, when user is logging on to vpn. I have added new 4.10 version to firewall, and removed old versions. I did a test with 10 users, and they all succeded. However that was from version 4.7...
Hi Cant find anything with google. Is it possible to stack 2960x switches of different models ? Like 2960x-FPD with 2960x-FPD with 2960x-FPS ?I got two FPD models already. And need some more ports. But i dont need the 10GB uplink if i can stack the s...
@Rob Ingram Well it was some strange behaviors.. I found some users today, installed DART getting ready to t-shoot... Well the users today was able to update without any problems So as of this moment i dont have any problems any way.. I have tol...
@Rob Ingram it all worked fine prior to friday where i added the image yes. I will try and find a laptop tomorrow with the 4.4 image on, and look at the dart. Thanks
I have experienced a couple of times now with 17.3.5c version, than when i shut down the active unit, vmware think its a good idea to reboot the standby unit before it should take over = 10-15min downtime on wifi...
1. show mac address-table | incl 'whatever specific you want. For instance if you want all mac address on vlan 100 but only on your local switch you could write show mac address-table | incl 100.*Gi That will include all lines with 100 in it, ...