Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,I'm using a cisco 3275 RAS bundle (30xMICA modems, 1 x E1 Module). I've successfully configured the 3725 for both dialin, using MS-CHAP-V2 authentication via a Microsoft 2003 IAS RADIUS Server, using Windows Logon Credentials.I've also configured ...
Hi,I’ve installed a Cisco 3725 RAS bundle (3725 PRI Dial Bundle: NM-30DM,NM-1CE1B, IP IOS), which works ok for incoming calls. I’ve installed Dialout-EZ in order for me to use virtual modems for outgoing calls.I can commumicate via the virtual com po...
Hi,One of our customers has recently had at least 5 of the above switches, fail. When the switches are powered up the switch freezes and will not boot - it stops with Amber System, Amber RPS and Green Speed LEDs on. I also have have green or in some ...
Is there a way of indexing individual VPN Tunnels statically, through a VPN3000 concentrator? If I MIB browse a VPN3000 concentrator, I can see the individual VPN tunnels each with ifindex numbers, so for the period this tunnel is active, I can colle...
Hi,I know this was a while ago, but did you ever get into your system, i.e. password reset. I've got a similar problem, with IGX with an npm-32, and got similar results from CCO.Regards,KK
Hi GP,I've attached a tracefile running debug on modem and modem trace all.Reverse Telnet works ok and using Hyperterminal. I've included this in the tracefile alsoHope you can help?Keith
I've since investigated this further by sending one off for repair. It looks like some of the components have been fried, due to a possible power surge, or something else like that!
I too am experiencing this problem with a number 3524 switches - exactly the same symptoms (ping response is only clean when ports are configured to 10Mb/s) and all appear to have the serial number FAB0601xxxx, which gives where and when the switch w...
