Hi All,I recently upgraded one of our ASA's a couple of weeks ago from 7.x to 8.0.3. This particular ASA currently only has the 1 VPN terminated on it and all is functioning OK. Yesterday I needed to terminate an additional VPN on the ASA but could...
Hi All,Sorry for the double post but I need to get this issue resolved ASAP.I am currently configuring a Cisco 877 router and I believe that I have run into a software bug with the 877.The unit shipped with IOS 124-4.T2, I was able to configure 4 add...
Hi All,I am currently configuring a Cisco 877 router and I believe that I have run into a software bug with the 877.The unit shipped with IOS 124-4.T2, I was able to configure 4 additional VLANs to the default VLAN through the VLAN database as expect...
Hi,I have created a QoS policy on a 100Mbps FE interface for an IP Phone and PC which will police traffic to cetain thresholds, any traffic over the configured limits will be marked down to scavenger class (DSCP 8). How can I best load the interface ...
Hi, I have a pair of 525's running in failover with 5 interfaces total. 3 physical and 2 logical, E2 has VLAN's 3 & 4 configured.My question is could I create another 2 logical interfaces (VLANS) but assign them to another physical interface, E...
Hi Rajesh,I run into the same bug some time ago whilst running 124-4T2, please see the attached url;http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&CommCmd=MB%3Fcmd%3D...
Hi,The following is taken fron the Q&A with regards to the Cisco 870 series router.Q.What does the integrated 10/100 switch provide?A.All models have an integrated 10/100 4-port switch. Cisco 870 series provide a Managed Switch with upto four 802.1Q ...
Mounir,With respect, I am fully aware that the 877 supports 4 802.1q VLANS in addition to the default VLAN, VLAN 1. When upgrading to the most current IOS (124-6.T2)the 877 now only supports 4 VLANS including the default VLAN. Plus i'm guessing my Q...
You could also enable LFI if you are using a leased line, for frame-relay you would enable FRF.12. I would also recommend tuning your maximum fragment size for 10ms serialization delay for both frame and leased line. If enabling cRTP on frame-relay y...
Bosalaza,You are correct in your statement as classification takes places prior to any marking and then the policing of packets, if any has been defined. My thought process is that I would expect to see any traffic outside of the policed limits to b...