You could add the "ip accounting" command to the interface and then do a "sh ip accounting". This will give you a list of source and destination IP's as well as the number of packets sent. This is good for detecting viruses like Blaster (1 packet, ...
Hi,I not sure I understand what you are asking. Are you indicating that the MRTG just made one set of graphs and stopped? And you would like it to update all the time, right? If so, yes, MRTG can do that. There are several ways you can get MRTG to...
HiI don't believe you have to specify a community SNMP on the wan interface. As long as the snmp settings are part of the global router config you should be fine. You do need to know what the public community string is however (usually "Public" by ...
Hi,I am not aware of any special command that you need to enable on the router in order to capture and graph wan utilization. MRTG queries the router using SNMP to get stats on the interfaces at intervals you setup within MRTG. As long as the syste...