Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I try to install Cat6000.cv50.v8-0.zip to get "unsupported modules" actief for 6500 -CiscoView 5.5 -packet Cat6000.cv50.v8-0.zipError : major versions are incompatible. required version 8.10 for cat6000 package.Only 8.0 is available on cisco-siteWher...
Is it possible to add RF cisco350-ios acces-points to RME3_5_IDU-11_0. for automatic configuration archive update ?With CM3_3_IDU-11_0 no problem to add cisco350-ios thx
Hi, I want to config our switches to do a auto shutdown of a port thats not used (no link) for example 1 month. And also sends a trap or syslog when this happens.Is there a cisco (cw2k) tool that can to this ?thx
Hi, I enabled our cw2k for syslog on all our cisco-ios devices. works fine.On our cat6500 series I also enable syslog and server ip,but still gets "no records found" using Severity Level Summary on RMEthis is what i configured at the cat6500 :#syslo...
I also upgrade to CWCS2.2. (on a solaris platform).Got the same error by installing IDU5.When I toke a closer look: I was installing RME3.4 IDU5. (thats a downgrade)By installing RME3.5 IDU 5 No problem.
Steve ,We're running 12.2(13)JA1 and higher.ANI-server devices supported shows cisco350-iosStill no discovery by RME3.5same for cisco1200-iosI upgraded from IDU5 immediate to UDI11 or is it necessary to instal IDU7 also ?thxkris
Set the BOOT parameters so that the switch boots up with the downloaded image when reloaded: For Example: switch: set BOOT flash:.bin(substitute the image name above for the IOS name you loaded to flash)Note: BOOT must be in capital letters. the swit...
