Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 350 AP that at one point had IOS on it. it seems to have no files in the flash right now... i'm trying to load ios back onto it using tftp... the tftp_init command doesn't seem to do anything and i get a permission denied error when i try to...
i know this sounds like a really stupid question and i'm sorry, but what is the easiest way to remove lines from the config on a pix 515 either through the console or from PDM, i'm running a pix 515 ios 6.3(3) and pdm 3nevermind- i got it...
a few months ago, i found documents on how to step by step make a pix, in my case a 515, connect over a tunnel to other firewalls from other manufacturers, it had detailed instructions on what to set on the pix and what to do on the other end... anyo...
I have a pix 515 running 6.3(3) and i need to reset the configuration to factory defaults. i understand that the command to do this automatically thru PDM isn't supported on the 515, so what can i do?
that doesn't seem to help, i have a newer version of the bootloader on there that doesn't respond to the same commands... i have the followingC350 Boot Loader (C350-BOOT-M) Version 12.2(13)JA TAC Support: http://www.cisco.com/tac ap: ? ...
that helps, thanks...i still want to find the document i was looking for though... it may have been something netgear put out... but i am pretty sure it is on the cisco side... oh well
