that doesn't seem to help, i have a newer version of the bootloader on there that doesn't respond to the same commands... i have the following
C350 Boot Loader (C350-BOOT-M) Version 12.2(13)JA
TAC Support: http://www.cisco.com/tac
ap: ?
? -- Present list of available commands
arp -- Show arp table or arp-resolve an address
boot -- Load and boot an executable image
cat -- Concatenate (type) file(s)
clear_ether -- clear ethernet port statistics
clear_phy_stat -- clear phy statistics
copy -- Copy a file
delete -- Delete file(s)
dir -- List files in directories
ether_init -- initialize ethernet port
fec_speed_read -- read fec speed
fec_speed_write -- write fec speed
fec_wire_loop -- ehternet external wire loopback
flash_init -- Initialize flash filesystem(s)
format -- Format a filesystem
fsck -- Check filesystem consistency
help -- Present list of available commands
led_test -- cycle led patterns
memory -- Present memory heap utilization information
mkdir -- Create dir(s)
mkdir -- Create dir(s)
phy_read -- read phy register
-- MORE --
phy_status -- display phy status
phy_write -- write phy register
read -- read at address
rename -- Rename a file
reset -- Reset the system
rmdir -- Delete empty dir(s)
set -- Set or display environment variables
set_baud -- set baud rates
set_sleep -- Pause (sleep) for a specified number of seconds
show_ether -- show ethernet port statistics
show_fec_queues -- show fec queues
show_fec_reg -- display fec registers
show_packet_buf -- show packet buffers allocation
tar -- extract or listing a tar file
test ram -- read at address
tftp_init -- Initialize tftp file system
type -- Concatenate (type) file(s)
unset -- Unset one or more environment variables
version -- Display boot loader version
write -- write at address
