Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've inherited a small network with 3 daisy chained switches and 1 meraki fw.There's 4 vlans on the meraki fw. (LAN 1, staff wifi 20, guest wifi 30 and cctv 50).Everything works fine across all 3 switches apart from the cctv vlan.That vlan works fine...
I originally never setup the mgmt interfaces until the first firmware update when i found i needed to get into the standby fw as well. So chose two IPs from a random unused subnet. (172.16.16.x). The mgmt interfaces are only used when i am on sit...
I went to update a pair of FPR1140 that are in HA yesterday using FDM.
I had read conflicting instructions online. Ciscos instructions were saying log on to the standby unit (which i cant as its in HA) so I went with some other instructions that sai...
Im trying to configure RSA SAML auth on our anyconnect VPN which was working fine with local users.
Its working fine on the clientless webvpn. It will authenticate no problem but it wont go through on anyconnect.
I connect on anyconnect and it bring...
Hi,
Does anyone know how to get ADSL working through a c1117?
We upgraded to one from a 1841 so I just copied the config over but the dialer wont get a IP address from the ISP.
If I look at the dialer int on the 1841 it has a public ip assigned to it...
Which trunk? The trunk between switch 2 and 3 does allow all the vlans in use or do you mean as in dont restrict the trunk at all?and for info the cbs 220 replaced a netgear (same type as what is switch 1) which had the exact same vlan 50 issue so n...
on switch 3 Spanning tree enabled mode RSTPDefault port cost method: longLoopback guard: DisabledRoot ID Priority 32768Address 34:70:69:5a:4a:16This switch is the rootHello Time 2 sec Max Age 20 sec Forward Delay 15 secNumber of topology changes 60 l...
vlan 40 was originally set for voip but isnt in use. Theres no acls on anything, all security is done on the meraki and vlan 50 works down to switch 2 so i wouldnt have thought its a security issue.
