Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've inherited a small network with 3 daisy chained switches and 1 meraki fw.There's 4 vlans on the meraki fw. (LAN 1, staff wifi 20, guest wifi 30 and cctv 50).Everything works fine across all 3 switches apart from the cctv vlan.That vlan works fine...
I originally never setup the mgmt interfaces until the first firmware update when i found i needed to get into the standby fw as well. So chose two IPs from a random unused subnet. (172.16.16.x). The mgmt interfaces are only used when i am on sit...
I went to update a pair of FPR1140 that are in HA yesterday using FDM.
I had read conflicting instructions online. Ciscos instructions were saying log on to the standby unit (which i cant as its in HA) so I went with some other instructions that sai...
Im trying to configure RSA SAML auth on our anyconnect VPN which was working fine with local users.
Its working fine on the clientless webvpn. It will authenticate no problem but it wont go through on anyconnect.
I connect on anyconnect and it bring...
Hi,
Does anyone know how to get ADSL working through a c1117?
We upgraded to one from a 1841 so I just copied the config over but the dialer wont get a IP address from the ISP.
If I look at the dialer int on the 1841 it has a public ip assigned to it...
Show VTP on switch 2 shows this but apparently the CBS switch doesnt support VTP.sw2#show vtp statusVTP Version capable : 1 to 3VTP version running : 1VTP Domain Name :VTP Pruning Mode : DisabledVTP Traps Generation : DisabledDevice ID : 04eb.4039.97...
unfortunately because the switch 3 is a cbs220 the commands seem to be reduced to normal ciscos.So show int trunk doesn't workshow vlan shows :VID | VLAN Name | Untagged Ports | Tagged Ports | Type-------+...
just in case anyone else comes to this thread the above diagram worked. im just missing either a fw rule to allow lan to mgmt so i can get on both mgmt interfaces or another port in vlan 10 for the same.
