Adam_S
Level 1
Level 1
Member since ‎08-30-2017
‎01-31-2024

User Statistics

  • 34 Posts
  • 0 Solutions
  • 19 Helpful votes Given
  • 1 Helpful votes Received

User Activity

Have configured an interface on cisco 2811 for DHCP, it is up/up but not accepting an address. I've attached a basic config and DHCP debug. Any advice would be appreciated, any further info can be provided.
Hi all,Need some help. I have a cisco 3845 connected to a 3750 switch. I am unable to ping external addresses directly from either the 3750 switch or 3845 router without a source address. Amel-router#ping 8.8.8.8Type escape sequence to abort.Sending ...
Hi Everyone, Looking for some help in regards to an extended ACL. I am trying to block access to all internal subnets from my 80.80.80.0 network, but permit access to from my internal subnets to modem (80.80.80.2). I've configured an applied an ACL b...
Hi All, Was hoping someone could help me here. I'm trying to connect a Netcomm (NF8AC VDSL) modem to a cisco 2811 and route internet through it but not having much luck with it. This is my first post so i apologise if something is amiss. I've connect...
Community Statistics
Member Since ‎08-30-2017 11:53 PM
Date Last Visited ‎01-31-2024 12:13 AM
Posts 34
Total Helpful Votes Received 1
Helpful Votes From