Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community,I have 2x 1262 wireless autonomous APs, but clients connected to the same SSIDs cannot ping each other. Can ping local gateway and gateway of different SSID. Clients have internet access. Have tested on different SSID. Same result. Issue...
Hi all,I have a Cisco C1111-8p that is refusing to perform NAT, more specifically it is not matching the ACL. I am attempting to migrate from an old cisco 3845, which the config was moved from and working fine.I can see that an Ip address is provided...
Hi All,Need some expertise with LG aircon. It suddenly disconnected from my wireless network, and refuses to reconnect (no changes were made). Occasionally it would reconnect and immediately drop off. I tested on a standard home router wireless with ...
Have configured an interface on cisco 2811 for DHCP, it is up/up but not accepting an address. I've attached a basic config and DHCP debug. Any advice would be appreciated, any further info can be provided.
Hi all,Need some help. I have a cisco 3845 connected to a 3750 switch. I am unable to ping external addresses directly from either the 3750 switch or 3845 router without a source address. Amel-router#ping 8.8.8.8Type escape sequence to abort.Sending ...
This turned out to be a issue with windows. Seems that disabling the windows firewall wasnt enough, there was a 2nd option called "windows domain firewall" that also need to be disabled.
Hi All,thanks to all who responded/contributed. I think ive managed to solve this. First of all I replaced the 3845 with a C1111-P. Issue still ooccured. So after much troubleshooting, I locked the the DHCP address to the aircon MAC so it always give...
Hi All,Thanks for all the input. I finally got to the bottom of it. Seems that Cisco IOS XE software handles NAT ACLs differently than the old 3845 IOS I was used to. In this version the ACL will only be matched if it references a Standard ACL and wi...
C1111-8P#show runBuilding configuration...Current configuration : 11325 bytes!! Last configuration change at 16:59:49 GMT Sun Aug 17 2025! NVRAM config last updated at 16:59:52 GMT Sun Aug 17 2025!version 17.3service timestamps debug datetime localti...
Yes. I have been suspecting a possible NAT issue. The NAT ACL has thepermit IP any any, permit tcp any any, permit udp any any statements andwas working previously along with the same IOS version. I also trieddisabling the TCP timestamps. I havent lo...
