Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I need suggestion, we have Data Center and Disaster Recovery connected with point to point link. link is connection our DC sever segment with DR server segment. It is mainly for replication of data. in future VM, vlan extension is possible.
No...
we have two ASA in multicontext mode. When I connect to primary after few min it got disconnect when I try to login again it login to secondary device.
13:31:11 GMT/BDT May 9 2018Standby Ready Failed Interface check
13:31:24 GMT/BDT May 9 2018Fai...
Hi I am running ACS 4.1. I want to check command run by user on the device. How can I check. AAA config of the device is as follows:-
aaa-server ADMIN protocol tacacs+aaa-server ADMIN (OUTSIDE) host x.x.x.xaaa-server ADMIN (OUTSIDE) host x.x.x.xaaa...
ASA1 is configured in multimode. ASA1 has a single crypto map entry with two peer IPs. IPsec tunnel is working fine with each peer. When we remove primary IP tunnel formed with secondary peer IP.
But the problem is when we put route for pri...
sh failover state
State Last Failure Reason Date/TimeThis host - Secondary Active Ifc Failure 13:31:11 GMT/BDT May 9 2018 TP-vpn inside: Failed L4-vpn inside: FailedOther host - Primary Failed Comm Failure 02:37:38 GMT/BDT May 16 2018
====Configurat...
failoverfailover lan unit secondaryfailover lan interface failover GigabitEthernet0/3failover key *****failover replication httpfailover link state GigabitEthernet0/2failover interface ip failover 1.1.2.1 255.255.255.252 standby 1.1.2.2failover inter...
