Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,our application team is mandating, that the solution we should come up with for SLB, should support Active/Active mode of SLB operation.My question, is this mode of operation supported/accredited by Cisco, and what is the draw back from the tradit...
Hi,I am trying to setup a lab to understand send IP traffic over MPLS cloud.The problem is, I loose BGP neighbourship with the CE once I applied "ip vrf forward xyz" at the PE interface to the CE. I re-enter the IP address after applying the cmd.I ha...
I am building Lan enviroment which will connect to the remote host via two redundant F/R links, the default gateway for the PCs is a VIP of HSRP/VRRP. The issue is how to track Frame-relay subinterface ?.Apprciate your advise.ThanksSami
How can I dampen an EIGRP interface if interface flaps for 5 times in 15 second. ?. I searched the net for this topic, I couldn't find clear cut answer. Thanks
Hi Haitham,as a problem isolation session, you may exclude the smtp from the interesting traffic in your access-list, at both end. See if you expereince the same level of slowness. This would isolate the possibility of congestion at your WAN, as well...
Hi Martin,I am glad you become involved. The cmd you recommended (show bgp vpnr4 unicast) is not supported in my IOS ver.Please see below:-r2_PE1#sh ip bgp vpnv4 ? * Display information about all VPNv4 NLRIs all Display information about all VP...
