About yugendhran

yugendhran · 07-14-2005

Hi"ip route A.A.A.A mask B.B.B.Broute-map xxxxx permit 101 match ip address 101 set ip default next-hop C.C.C.C"The static route is created for destination IP A.A.A.A . Source based routing policy has created to send the traffic to different GW C.C.C...

yugendhran · 06-24-2005

Hi,I can create Mac-accesslist, but there is no such a command to bind the mac accesslist to any interface of Cisco Catalyst 2950-48T with latest code 12.22EA4. Please suggest me how to configure the Mac accesslist in Layer2 switch and give me soluti...

yugendhran · 05-26-2005

Hi,Can you give me the reason for showing ''txload 10/255 , rxload 42/255" from the below output?__________________________________________________Serial3/3 is up, line protocol is up Hardware is M4T Description: -----Singtel Link------ Internet a...

yugendhran · 05-25-2005

Hi,The router (3640) is sending voice packet across the network when my CPU utilization is 40% - 50%.Is there any delay occurs on Voice packets?. The router is handling both data and Voice packets. Please confirm me. In Show buffer command I can see ...

yugendhran · 05-12-2005

I am using 3640 and two 2610 router. All the traffics from my network are reaching the 3640 router. The 3640 is rerouting the packets from a particular network where the other two WAN links are terminated at other two 2610 router. I am seeing more in...

yugendhran · 07-14-2005

Hi,I am doing tracert from PC (10.20.150.10) to destination IP 216.136.230.14. Routers are not in triangle manner''ip route 0.0.0.0 0.0.0.0 203.76.140.201ip route 216.136.230.0 255.255.255.0 203.76.140.201 (ISP router GW)access-list 101 permit ip 10....

yugendhran · 07-14-2005

Hi,I am doing tracert from PC (101 list) to destination A.A.A.A. It is going via B.B.B.B GW not C.C.C.C (as defined in Route maps 'Set ip next-hop'). FYIip route A.A.A.A mask B.B.B.Broute-map ebslash permit 101 match ip address 101 set ip next-hop C....

yugendhran · 07-14-2005

Hi,I changed 'Set ip default next-hop' to 'set ip next-hop', I didn't remove static route. My next-hop IP address is directly connected network and it was up, eventhough it didn't go via C.C.C.C GWRegardsYugendhran

yugendhran · 07-14-2005

Hi thisisshanky,Thanks for your information. I have gone through the link. Please conclude, If we use 'set ip default next-hop' it checks the routing table based on destination IP address, doesn't it?. So if remove the static route for the destinatio...

yugendhran · 07-14-2005

Hi,I am getting CRC error in LOCAL LAN side also . I changed the cat5 UTP cable also, eventhough it is showing CRC error. The packets are being rerouted by another router to this router (PBR). The WAN link problem is rectified.Thanks for your help to...

Member Since	‎12-31-2003 03:17 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	21

User Statistics

User Activity

route-maps (PBR)

mac accesslist

TX & RX load on Serial interface

CPU utilization on VOIP

CRC error while doing PBR

Re: route-maps (PBR)

Re: route-maps (PBR)

Re: route-maps (PBR)

Re: route-maps (PBR)

Re: CRC error while doing PBR