Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,
Please advise me for the below issue.
I have a FEX ( N2K-C2232TM-E-10GE ) connected to two Nexus 7010 as dual home. The FEX is online in both Nexus 7K , however when we are connecting any server ( Dell) in the FEX port its showing :"Link...
Hello Deepak,
I am looking for a support to have similar setup with more than 40 devices ( Scada PLC) having same IP and need to access from outside. I hope we may use a router which have 48 Port to do both NAT and VRF. Appreciate your advsie...
Hi Chris and Balaji
The issue has been resolved. This model FEX only support 1/10G and not 10/100 mbps. So the servers ports are in 100mbps and they have changed the speed to 1Gbps and start the ports are up.
Thank you for the support.
Hi Chris,Thank you for the support.1. I will give you the output of requested commands.2. What model of Dell server are you attempting to connect the FEX to?= Need to check on the model of the Dell server3. Have you attempted to utilize another inte...
HI Balaji,Thank you for the support. Please find the Cisco data sheet for this fex below"Cisco is introducing the Cisco Nexus® 2232TM-E 10GE Fabric Extender as part of the Cisco Nexus 2000 Series Fabric Extenders (Figure 1). The Cisco Nexus 2232TM-E ...
