Let s supose the scenario VTP Server (Domain " ", Revision Number 1) - VTP Transparent (Domain " ", Revision Number 0) - VTP Client (Domain "cisco", Revision Number 3) Will the VTP client switch update the name of VTP Server switch to "cisco" and ...
Hello Gents, Would like to have your support to understand the following content of a MAC ADD Table for SW1. I have 3 switches interconnected with trunk links : SW3 (with a native Vlan 99, ip 192.68.1.3) - SW2 (with a native Vlan 99, ip 192.68.1.2) -...
I am mixing the concepts between P2P links and trunking: "RSTP can only achieve rapid transition to the forwarding state on edge ports and on point-to-point links. The link type is automatically derived from the duplex mode of a port. A port that ope...
Just to confirm : With Pagp the max number ports to form an Etherchannel should be 8 and with Lacp 16 (where 8 are active and the other 8 will be acting as backup ports) However, in Packet Tracer it is possible to configure a port channel with no num...
Hi Francesco and Julio,
Thank you for your feedback and explanation !
I have just got confused because when we have the following scenariowith a empty domain the server updates the client with his vtp domain, in this case "cisco". In the below ex...
Hi Francesco, Thank you for your quick answer.I completly agree with your statement but this is a special scenario :The domain is still empty, there is no domain for server and for transparent. For example when : VTP Server (Domain "cisco", Revision ...
Hi Mark, Thanks for your reply.That s clear for me, But i still have doubts regarding thsi topic.Maybe you can support :) Doubt:I have just 3 switches interconnected without any clients, I know these Dynamic addresses belong to STP BPDUs messages exc...
Hi Alex, Thanks a lot for your quick feedback and explanation.However, I have still have doubts regarding this topic when I saw this sentence in the cisco theory.Does RSTP not work with trunk links ?I know the link types are Link-Type point-to-point...
