Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there. When you use the Root Primary command in the Spanning Tree Protocol, the Priority value is automatically set on the Vlan. If you have a small network structure, for example, you have two main switches and you will not have any problems i...
Hello there. You can easily configure the Spanning Tree PortFast feature in the GNS3 program. In GNS3, the PortFast feature works fine. From the following link, you can browse the relevant article for PortFast configuration. Source: Spanning Tree Por...
Hello.It is possible to use a more compatible Layer 3 Switch in the GNS3 program and it works very well. You can add L3 Switch to the GNS3 program from the following source. GNS3 Layer 3 Switch Respects
