Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is the config on the access server:!!!!clock timezone EST -5clock summer-time EDT recurringip subnet-zerono ip routing!!!!interface Ethernet0 ip address 10.38.2.7 255.255.255.0 no ip route-cache no ip mroute-cache!interface Serial0 no ip address...
Ok, so I've heard many different opinions about how to configure STP in the network. I want to know what is the correct way to configure STP between the distribution switches and the access switches? We have redundant links going between them. Her...
So far we have rapid pvst running on our core and pvst, mst running on the access layer. We have turned spanning tree off on a number of vlans on the access layer because of the huge amounts of loops we had on the flat network that used to be in pla...
There has been problems with our network when the switches power up, the GigaStack starts flapping and continues to flap loosing network connectivity intermittently. Is there any way to keep this from happening?
Make sure to disconnect the session properly by using disconnect session # and if the line still shows it's being used, use the command clear line # where the number is the line you want to disconnect.
Here is the show line and show line 1 output: Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int 0 CTY - - - - - 0 0 0/0 -* 1 TTY 9600/9600 - - - - - ...
