Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently attempted to convert individual 3850 switches into a switch stack, but the switch that I attempted to configure as primary became a member instead so now I'm trying to remove the switch stack config and revert it back to the prior state. T...
Hey guys, I'm trying to configure multiple SNMP community strings on a Cisco ASA5506 running v9.8.2. We're working with another company to have the ASA monitored, but I don't see a way to add another SNMP community without having the existing one ove...
I'm trying to allow NTP traffic from a Cat 3650 switch to a Nexus 9k, which are neighboring switches, over a trunked interface. The Cat 3650 doesn't have a working default gateway so I configured an address associated with a VLAN on the Nexus switch....
Had an issue like this before and it was stack member related, but this time the only issue is a module light coming up as amber. It doesn't appear to be hardware related, but I'm not sure. License Information for 'WS-X45-SUP7L-E'License Level: ipbas...
I'm trying to create a local ssh read-only account and set it up on Secure ACS, but haven't had any luck. I've created a user, but the credentials don't work. Suggestions would be greatly appreciated. I would open a TAC case, but support has expired....
The software install command or almost no other "software" commands are available. CNSD-I022-B2F1A04-war#CNSD-I022-B2F1A04-war#software ?% Unrecognized commandCNSD-I022-B2F1A04-war#conf tEnter configuration commands, one per line. End with CNTL/Z.CNS...
Perhaps I didn't explain the issue correctly. I am using the community keyword when configuring SNMP, but I cannot configure 2 or more on the ASA: snmp-server community Test1snmp-server community Test2 Is there a way to create these 2 without one ove...
That's not a valid command: SJCAT3650#ping 10.10.202.252 vrf Mgmt-vrf^% Invalid input detected at '^' marker.SJCAT3650#ping 10.10.202.252 vrf ?% Unrecognized commandSJCAT3650#ping 10.10.202.252 ?data specify data patterndf-bit enable do not fragment ...
