Had an issue like this before and it was stack member related, but this time the only issue is a module light coming up as amber. It doesn't appear to be hardware related, but I'm not sure.
License Information for 'WS-X45-SUP7L-E'
License Level: ipbase Type: Permanent
Next reboot license Level: ipbase
cisco WS-C4507R+E (MPC8572) processor (revision 6) with 2097152K bytes of physical memory.
Processor board ID FXS1822Q0YV
MPC8572 CPU at 1.5GHz, Supervisor 7L-E
Last reset from PowerUp
2 Virtual Ethernet interfaces
200 Gigabit Ethernet interfaces
4 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Configuration register is 0x2102
MatawanVoice_4507-1#show env
no temperature alarms
Module Sensor Temperature Status
------+--------------------------+--------------------+------------
1 Air inlet 31C (56C,68C,71C) ok
1 Air inlet remote 22C (46C,59C,62C) ok
1 Air outlet 32C (66C,76C,79C) ok
1 Air outlet remote 27C (60C,71C,74C) ok
2 Air inlet 30C (56C,68C,71C) ok
2 Air inlet remote 22C (46C,59C,62C) ok
2 Air outlet 32C (66C,76C,79C) ok
2 Air outlet remote 26C (60C,71C,74C) ok
3 XPP 32C (52C,64C,67C) ok
3 XPP Remote 40C (61C,75C,78C) ok
3 IFE 29C (56C,68C,71C) ok
3 IFE Remote 34C (61C,74C,77C) ok
3 CPU 27C (47C,61C,64C) ok
3 CPU Remote 34C (61C,77C,80C) ok
4 XPP 29C (52C,64C,67C) ok
4 XPP Remote 33C (61C,75C,78C) ok
4 IFE 27C (56C,68C,71C) ok
4 IFE Remote 29C (61C,74C,77C) ok
4 CPU 25C (47C,61C,64C) ok
4 CPU Remote 36C (61C,77C,80C) ok
5 Air inlet 30C (56C,68C,71C) ok
5 Air inlet remote 22C (46C,59C,62C) ok
5 Air outlet 29C (66C,76C,79C) ok
5 Air outlet remote 24C (60C,71C,74C) ok
6 Air inlet 29C (56C,68C,71C) ok
6 Air inlet remote 21C (46C,59C,62C) ok
6 Air outlet 30C (66C,76C,79C) ok
6 Air outlet remote 25C (60C,71C,74C) ok
Power Fan Inline
Supply Model No Type Status Sensor Status
------ ---------------- --------- ----------- ------- -------
PS1 PWR-C45-4200ACV AC 4200W good good good
PS1-1 220V good
PS1-2 220V good
PS2 PWR-C45-4200ACV AC 4200W good good good
PS2-1 220V good
PS2-2 220V good
Power supplies needed by system : 1
Power supplies currently available : 2
Chassis Type : WS-C4507R+E
Power consumed by backplane : 40 Watts
Switch Bandwidth Utilization : 0%
Supervisor Led Color : Green
Module 1 Status Led Color : Green PoE Led Color : Green
Module 2 Status Led Color : Green PoE Led Color : Green
Module 3 Status Led Color : Green
Module 4 Status Led Color : Orange
Module 5 Status Led Color : Green PoE Led Color : Green
Module 6 Status Led Color : Green PoE Led Color : Green
Fantray : Good
Fantray removal timeout : 138
Power consumed by Fantray : 165 Watts
MatawanVoice_4507-1#show module
Chassis Type : WS-C4507R+E
Power consumed by backplane : 40 Watts
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1 48 10/100/1000BaseT Premium POE E Series WS-X4748-RJ45V+E CAT1831LA24
2 48 10/100/1000BaseT Premium POE E Series WS-X4748-RJ45V+E CAT1831L96R
3 6 Sup 7L-E 10GE (SFP+), 1000BaseX (SFP) WS-X45-SUP7L-E CAT1832L1WZ
4 Supervisor
5 48 10/100/1000BaseT Premium POE E Series WS-X4748-RJ45V+E CAT1833L0TL
6 48 10/100/1000BaseT Premium POE E Series WS-X4748-RJ45V+E CAT1833L0TQ
M MAC addresses Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
1 f07f.064c.d1b0 to f07f.064c.d1df 1.5 Ok
2 f07f.064c.c6d0 to f07f.064c.c6ff 1.5 Ok
3 f40f.1b5a.aa40 to f40f.1b5a.aa45 3.0 15.0(1r)SG10 03.07.03.E Ok
4 Unknown Unknown Unknown Other
5 f07f.0673.7030 to f07f.0673.705f 1.5 Ok
6 f07f.0673.6f40 to f07f.0673.6f6f 1.5 Ok
Mod Redundancy role Operating mode Redundancy status
----+-------------------+-------------------+----------------------------------
3 Active Supervisor SSO Active
4 Standby Supervisor SSO Disabled
Anyone know what the significance of Module 4 Status Led Color : Orange is?
Thanks!
