Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am not able to generate CRM syslog reports. I checked the syslog file and it is still collecting messages but when I try to use CRM to display them, I see zero (0) messaages. Any thoughts...anyoneThank you in advanceb
I have two VPN concentrators that I upgraded the memory to 512M. Also, I update the software to latest release (Jun 2006). One of them was able to see the RAM ? 512M- right away and the other one was not. It was only seeing 256M (2x256M). I have did ...
I have many switches of various types. I would like to reduce the number of VLAN per switch. 1) Use switchport Trunk Vlan allowed...2) Change VTP to transparent mode. Can this be done while the switch in production?Are there other ways to reduce the ...
I have installed LMS 2.5 and Campus Manager 4.0.2. I have discovered the devices using the Device Seed option by importing the seed into the Campus Manager. Under the Capmus Manager -->Administration. the Device Discovery has been running since Frida...
I am planning to move these switches to a new power source and I do not want to power them off. Each switch has 2 power supplies of equal values and both are in redundency mode. one switch is full of blades (6509) and the other is about 80% full. The...
When trying to redistribute Static routes so that servers can see them, it did not work. However, the default meteric was not changed at this point. I am not sure if that would have made difference.Thnxbzarrug
When trying to redistribute Static routes so that servers (user RIP as well) can see them, it did not work. The default meteric was not changed. I am not sure if that would have made difference.Thnxbzarrug
