Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a scenario A Cisco 2900 Router connected to InternetA Catalyst Core Switch configured with all VLANsAccess Switches connected to End devices Now the client machines are configured with Local DNS (the DC Address), DNS for Internet. Now s...
Hi Everyone,I have 2 queries1. After we configure the IPSec VPN in a Cisco Router, how do we identify and check that the traffic is flowing through the tunnel? Are there any commands and ways to find it out?2. What are some of the troubleshoot...
Dear All,Please find my requirement in the two figures below Figure 1Figure 2Brief Synopsis In Figure AI have a Router and two ISP links connected to it. The other end of the Router is connected to the LAN via the Switch In Figure BI have two Router...
Hi All,The Core Switch has been configured with VLANs and it's respective IPs as given in the picture and have been synchronized to the client switches through VTP. I wanted to configure the Client Switch Access1 with an IP to access it through Telne...
How do I do Routing between selective VLANs? Say if there are 3 VLANs 10,20 and 30, and if I want to enable Routing between 10 and 30 and not between others, then how do I do it?Consider that the VLANs are configured on the L3 Core switch and VLAN in...
Thanks for the answer, does the ip name-server specify the DNS, so that when client traffic hits the router it uses it for name resolution? Where do we setup the tertiary DNS? on the Windows server?
Hi Thanks for your reply, I found an accepted solution in one of the earlier questions pertaining to the same topic, I have attached the config file.Can you go through it and let me know if it is fine on your perspective?
