Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have version 9.19(1)31 and Where used cannot work too.The quality of Cisco ASA SW has decreased. We upgraded SW of our ASA 2130 because of vulnerability. Our version met problem with partially lost configuration that caused 3 service outages. So w...
I have problems with non responding SNMP too. Our version is 9.16.19 and HW is FPR-2130 and sometimes some contexts started to ignore SNMP requests. In this case I delete SNMP configuration at affected contexts or switch failover active member, reboo...
This command "show system reset-reason" does not work for me too. Cisco IOS "show version" shows reload reason so I was looking for similar command for Firepower. It seems it does not exist.
I met the same issue and our ASA version is 9.16(2)14. Someone in another discussion suggested a reboot and it helped. So I suppose the problem is related to the current state of the firewall where it is not possible to add another ssh users on some ...
I got similar error and based on previous hint about wrong logging options I found that regional letters were used in a rule name. After changing to pure ASCII the script continued in rule processing and the rule that had failed was processed correct...
