Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Scenario:2 Cisco 9600's with sup-1 cards connected in a SWV pair. We have configured SPAN on switch A, the source being ALL VLAN's and the destination interface being a port on switch A. My question is, with this configuration, would ALL VLAN traffic...
Hi, I have a customer who has installed a Nexus 5672UP switch. It is configured ports 1/1-40 as ethernet ports and ports 1/41-48 as fc (unified) ports. They currently are using all ports except for port 38 which is spare. They are looking to convert ...
Hi! So I have a really weird issue since I migrated an SVI from my current Core switch to a new Catalyst switch. The back story is, we have physically migrated all edge stacks from our current core to the new core. The SVI's for the clients/phones et...
Hi All,
I'm in the process of testing a newly provisioned pair of Catalyst 9607R. I wanted to shutdown a specific module in either of the switches. I followed the Cisco guide 'powering down a line card' for my version of software (17.9) which states ...
We have recently noted a flood of SNMP related logs which a snapshot are shown below (full logs attached). As shown, they were all logged in a short space of time. There was no issues on the network reported at the time and no other switches of the s...
Hi, Thanks for the response.That were my thoughts looking at this logically. However, reading the Cisco Docs, it does state that when configuring VLAN's as the source, the data for ALL the listed VLAN's would be copied regardless of what interface it...
Hi, I will post a topology later today but really there is nothing in the path. In essence, we have a layer 3 switch which is configured (SVI) and is acting as the gateway for the affected hosts. This core switch has a direct layer 2 connection (2 po...
Hi,
I have now run the command you suggested correctly and it has worked as I wished:
Note: this command only works on line cards and NOT sup cards, whether redundant or otherwise.
Thanks,
