Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have to module WS-X6148-GE-TX and I have to message "dot3StatsSymbolErrors" with error. I see my server giga, but I not have menu for modify parameter of reception... Any know this problem ?> 12 dot3StatsSymbolErrors = 499> 0 txPau...
Hi, I have two service provider with access to Internet and I like load balancing this links.... Is possible ?for example, service provider 1 only HTTP and service provider 2 all not HTTP. ¿?
Hi, I have the same problem... I have this counters in any interfaces Giga. Only module Giga12 dot3StatsSymbolErrors = 90 txPause = 01 rxPause = 00 rx...
Hello, I have System Bootstrap Version: 5.3(1)System Boot Image File is 'bootflash:cat6000-supk8.7-6-9.bin'System Configuration register is 0x2Hardware Version: 3.0 Model: WS-C6506 Serial #: TBA05150320PS1 Module: WS-CAC-1300W Serial #: AC...
Problem is that I not have access to console... I connect the cable console, but I not see the prompt... I need reset all config for hardware, not "recovery password", (jumper)
Josef,I need a device able to receive in schedules peak a quantity of 1400 simultaneous calls for a payment service. This is to begin and later we hope they are more than 2000 the calls and obviously the device should be scalable. I was seeing and I ...
