Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there specific configs to allow vpn traffic behind PIX firewalls. We have a client using 4.6 that is behind two PIX firewalls but is unable to connect. We've open up pretty much everything between the client and endpoint just to rule out any block...
We're using the Cisco IDS system, specifically VMS and a IDSM2 module on our 6509 switch, with all the updates. I've been tracking down P2P traffic, and it seems to catch all except for the napster traffic. I've looked through the file sharing sig gr...
Is there a configuration to have a backup authentication for the enable mode for the PIX 501. I currently have a 501 configured to authenticate to a AAA server, but want to have a backup like a local authentication, in case the connection is lost, an...
Does anyone have a configuration to have the ability to telnet from the outside network to a Cisco PIX? We're using a 501 within our network that is protecting a group of servers, but our administrative network and aaa server would be located (consid...
I've noticed that LMS and RWM solutions have some of the similar packages, Does anyone know if you can just buy one solution and add the other packages, or do I have to buy both; and if I buy both, is it possible to install both solutions on one serv...
1 - we moved the client so that it's only behind one firewall now and it is using it's public IP address2 - client is using 4.63 - it is terminating to a VPN concentrator4 - the sysopt command is there, we didn't do the nat-traversal since where not ...
