Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have some disagreement on what is the best practice for setting up the management port on a cisco router. Some people say connect it directly to the internal network, bypassing all firewalls. Some say this could be a vulnerability in case the ro...
I have 2 4402 controllers with ~20 APs on each. For some reason, all the APs will go down on one controller and migrate to the other, like the controller has gone offline. This only happens to one controller. I've checked the network switches and ...
No qos commands work on this. Im guessing I need to upgrade the IOS but I'm not sure what version to go to. I also only have 24576K memory so I'm rather limited. Is it possible or will I have to buy more memory or a new router?
I have a PIX 525 ver6.3.3 with a failover. I used to be able to connect to both pix firewalls but now I cannot connect to the active firewall via the main internal interface. I can connect to it from a different interface I originally set up for ma...
I turned the 'bad' controller off, but I am getting many of these errors:An Alert of Category Security is generated with severity 1 by Switch controller_1/192.168.1.50 . The message of the alert is IDS 'Disassoc flood' Signature attack detected o...
I can always connect to (via the dpm) the secondary/standbye pix. I cannot always connect to the primary/active pix. This is via the same PC.When I couldn't connect to the primary/active pix via the internal interface I used a laptop to connect to ...
I can ping the active pix just fine. I get an IE error of 401 I believe. Whats weird is I just tried it this morning and it worked.....I changed nothing.
