Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Curious if anyone else on East Coast notice about a 20 minute outage with OpenDNS around 2:40 PM today. Support is saying everything is fine, but our two nodes could not connect to the Umbrella DNS Servers .Our ISP was up and we could ping IP address...
We are in the process of setting up a Hybrid Cloud/ On-prem Exchange environment. We can successfully connect over port 443, but when we try to send emails over port 25 we are getting a SSL Block. We are using the Decrypt - Known Key rule set up usin...
We are moving our primary internet to a new location and will have a new public IP and gateway. Is there a way to assign the new IP to the outside interface of the FTD, and somehow keep all of our Site to Site VPN tunnels using the existing IP (yes, ...
We are looking at moving a set of FTDs that are running in HA to a new subnet and will reconnect to the same FMC once they are moved. I am not having any luck finding the instructions on how to do this. Any help would be great.
We had to replace one our our standalone FTDs because the original one crashed on us. The new one is up and we are able to connect via the management interface and restored from a config backup, but the outside interface will not connect. We made su...
If we went back to the original AP it would connect right away, if not it would take 3 minutes to join the new AP. Our port authentication timer inactivity config is set to 3 minutes.
We found the issue, it was related to the config on the new 9400 switch and using 802.1x authentication. We had to add auth mac-move permit to the config. This was something that was enabled by default on the 4500s but not on 9400s.
