About jgould0011

jgould0011 · 03-10-2015

Hello, I have 2 SG500 52 port switches in a stack. One is non-POE and the other is POE. I use the POE switches primarily to drive our Yealink T22P and T46G phones. They have worked flawlessly for about a year. This weekend I updated the firmware an...

jgould0011 · 11-28-2016

I was able to get the switch working again, BUT this really seems like an issue with the switch firmware. I've had the same problem across 3 different firmware over the years (I've been running the latest for this last incident). I tried to power cy...

jgould0011 · 11-22-2016

I found this thread and HAVE to reply because I know see my problems are definitely related to this. I have a few SG500-52P. I've replaced the one about two years ago, same thing happened again about a year after that, and today I find that it happen...

jgould0011 · 05-16-2016

Don't waste your time. Call Cisco support, the switch port is busted. You will need a replacement.

jgould0011 · 03-10-2015

Yes, that is what I did initially. I have since tested it at the switch itself. Same behavior. Also, strangely, the switch port light on the right of port 36 doesn't come up amber. Plugged into any other port and it does. I just got done with Cisco s...

jgould0011 · 03-10-2015

More info to help diagnose: SG500#show power inline Port based power-limit mode Inrush Test: Enable Legacy Mode: Enable Unit Power Nominal Power Consumed Power Usage Threshold Traps Temp (C) ---- ------- ------------- ----------------...

Member Since	‎03-10-2015 08:41 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	6

User Statistics

User Activity

SG500 POE issue on one port, worked fine for over a year!

I was able to get the switch

I found this thread and HAVE

Don't waste your time. Call

Yes, that is what I did

More info to help diagnose: