Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
PASSWORD RECOVERY IS DISABLEDGot this message on 3630.Tried to use Cntl-Break.It help me get to the question:Do you want to reset the router to factory defaultconfiguration and proceed [y/n] ? Then I enter "y" and got next message:Reset router config...
I have PIX authentication for getting to Internet.When I open IE window and go to internet I get challenge and after I put username and password I can get to Internet.Authentication happens just one time.If I am not authenticated yet and I am readin...
Is it possible to let client to access local LAN and Internet?I did it with VPN Client 3.6.2A and it works just fine. But pptp not.So is it possible at all?
Question is:If I put version 7 to vfc then it going to work. But I'd like to know what is the differences between DSPM boards or between C549 or between AS itself that let it have last vfc software.........Here is some info:Router#show vfc 1 version ...
After upgrade from 3.1 to 3.2 I found that MWI stop work....I had few partition on CM. I also have Unity 2.6.When I assign MWI DN to partition and calling space it start work for one group....Unity could be configured to work with one MWI on and one ...
It depends....I did not try but if it will load software from the flash and you have no access to config then how you can make router boot from flash card?
Man...Of course I read it.... This is the only close match in google....But as I told.... I have it solver by booting from old OS version that do not know a bit about that command - " "service password-recovery" That is it.
Solved.Put 11.2 as software(on other flash). Then it works.I think that IOS 12 with "service password-recovery" and some combination of register close box and standard password recovery.
It is the point....I can not get to the bootrom and interrupt boot process....I believe that "service password-recovery" command was used.And also configuration register....So If you read my first posting than I was able get this message that should...
