Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Friends,I have an very simple configuration to create some vlan basis on my office floor wise lan network. And for internet connectivity port fa0/2(ip = 20.30.40.101/8) of L3 switch is connected to Firewall port in actual but in diagram it is s...
Dear All, I'm using Cisco controller 2500 with four access points.I'm using single WLAN right now.But my plan is to use 2 WLAN for WiFi users for example one WLAN for laptop users and others for cellphone users but i don't want to give full bandwith ...
Hi Andre Neethling Actually i put ip route 0.0.0.0 0.0.0.0 20.30.40.100 on layer 3 switch to enable default routing for all vlans towards Router port. Later i put ip route 192.168.2.0 255.255.255.0 20.30.40.100 to check my configuration for single VL...
Hi emora6001, Do you think any configuration need to be done on router side too because i just want to ping router connected port with all VLAN, Actually in my real scenerio i'm using firewall instead of Router which simply NAT wan to lan traffic..An...
Hi Wellington, You have given information about Cisco 5500-series-wireless-controller while i'm using 2500 series controllor. Unfortunaitley Flex Connect feature is not there and even in QOS when we edit profile there is no Rate Limiting of the per-S...
