Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a vlan30 for my voice and vlan1 for my data, need to connect my ip phones to ms250 then from iphone connected to my laptop.how to set multi-vlan access port in ms250? Any documents or videos?Thanks!Regards,Marco
Hi all,We have 2 ms250 I want to create lacp to increase throughput and provide redundancy incase we loose connectivity from our stack connection. Can provide the correct configuration on the port?Thanks!Regards,Marco
Hi All,
We have cucm & cisco gateway. I created a displan for our Philippines offie. So when I use 8.! no issue i can dial local landline/mobilde/ndd/idd.I need segregation for the dial plan since some users need FAC to controls the calls.Below are m...
Hi Cisco,
We have acs 5.4 and currently under default network access identity is set to our AD because we use it for our wireless. Is it possible to set default device admin identity to internal users without affecting the setting on default networ...
hi All,
we have cisco 7911g when i regsitered it to our cucm then when you call from this number it's displaying incorrect caller id.It displayed our main trunk line number.by default when u made i call from this phone it should display 2200 1216 b...
Another concern, from my meraki switch going to firewall and router can we use lacp for redundancy as well. Coz currently I only have one line going thru firewall and another one going thru router.
Hi Adam,I already have stacked the 2 ms250 via the stacking cable. Need to implement lacp for increasing throughtput and also incase the stack loose connectivity we have a backup connectvity on both of the switch. Is this the best practice or any re...
