About belovell

belovell · 03-04-2012

There are a number of guides on the internet related to Windows CA and iPhone but I did not feel that any of them put all the peaces together such that someone could get AnyConnect certificate authentication up with little fuss. Hence, this document....

belovell · 08-23-2010

Very little info to go on but...I wouldn't pay attention to the flood bit as depending on the port config and other thingss it could be normal.I think the key here is that you said the mcast should never get to the 6500. If this is the case it is lik...

belovell · 07-16-2010

Not familar with the output from that command. The common way to look at switching path stats for IOS is "show int stats" which will show how many packets hit each switching path on an interface.-Ben

belovell · 07-07-2010

Just to double check make sure you try removing and adding the policy back once "mls qos trust dscp" was removed. They might have gotten into an argument with each other as the "trust" command sets a bit in our internal header that precludes remarkin...

belovell · 07-01-2010

mls qos trust dscpI don't think you are allow to do this and manually rewrite QoS values. It's either or. -Ben

belovell · 06-29-2010

I see that you have a ip helper address on the BVI but it does not make any sense if the helper address is on the same subnet. ip helper is for off subnet.Also I see the folowing commands on the dot1 radio interfacebridge-group 1 subscriber-loop-cont...

Member Since	‎05-25-2005 02:29 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	27
Total Helpful Votes Received	20

User Statistics

User Activity

AnyConnect iPhone certificate authentication + deployment

Re: Debug netdr

Re: Process Switching out on an ATM PVC in MLPPP bundle

Re: 6500 VSS policy-maps and classification

Re: 6500 VSS policy-maps and classification

Re: Cisco 857W wireless clients dhcp issue after IOS upgrade